How to build your own air freshening solution by cutting the screwdriver and using the screwdrivers to pry the top cover of the container.
The instructions were a bit long and the screw driver was rather hard to find.
Here’s what you need to do. 1.
Make the screw cap.
You need a screw cap to attach the screw on top of the bottle.
Make sure it’s a flat, flat-head screw, not a long flat screw.
2.
Cut the screw to the size of the screwcap.
Use a small flat-headed screwdriver to pierce the top of your bottle and the cap, using the length of the screws.
3.
Use the other end of the small flathead screwdriver (the one you used to cut the screw) to poke the cap out of the top.
The cap should pop out.
4.
Screw the screw into the bottle cap.
Be sure the cap is tight.
Make certain that it’s snug.
5.
Close the cap and use a screwdriver on the screwhead.
If the screw isn’t tight, it won’t come out.
6.
Now you’re ready to use the screw.
Take a small piece of tape and cut out the screw and tape it to the bottle, just enough to fit the screw in the cap.
7.
Now, place the screw caps on the bottle and fill the cap with the water you just saved.
8.
Put the cap back on the top and screw the cap shut.
Repeat for the other bottle, the one that you saved.
9.
Repeat until all your air freshing solutions are empty.